Collectors are mounted with
Southern orientation on roof, or on the ground. Heat
generated from the sun’s rays enters your pool in one of two ways:
1) through a heat exchanger (for year-round applications) or 2) directly
through a solar loop plumbed after the filter and before any pre-existing
heater (seasonal use).
1) Year-round, closed
loop systems - durable, versatile, high temperature, dual purpose
(pool water and domestic hot water), freeze
protected with non-toxic glycol-water mix in a closed loop design, heavy
duty, efficient heat exchangers, differential control automatically
operates a small pump during solar hours to remove heat from the collectors
into the pool or tank
2) Seasonal (Summer)
Use, low temperature systems–
Solar
doesn’t have to be expensive and high-tech. Ecosun collectors
can be installed anywhere that receives good solar exposure and by anyone
with plumbing skills. These simple systems offer the greatest affordability
for renewable energy in our region. A relatively large area of piping,
typically half the surface area of the pool, is required for these unglazed
solar collectors.
The following information
on Ecosun collectors was made available from Thermo-Technologies:
Ecosun Low-Temp Solar
Pool Collectors
Strategically placed slots
in the webbing of Ecosun Collectors prevent moisture buildup under the
collector to preserve the life of the roof. These same slots allow pressure
relief during high winds. This combination of features is unique to
Ecosun and blends all the strength and performance of a full collector
with the benefit of wind load protection and moisture ventilation for
your roof.
Ecosun Collectors have been designed from over twenty years of experience
in the manufacturing of solar heating equipment. They have undergone
extensive testing resulting in performance certification by accredited
independent laboratories and approval agencies. Performance rated at
over 1,000 BTU's per square foot (low temperature, no wind) by the Florida
Solar Energy Center.
The Collectors are generally
mounted on the roof but can be mounted on a ground rack. Using the pool
pump, water is circulated through the hundreds of specially designed
channels in the solar collectors. Pool water is heated in the high performance
Ecosun Solar Collectors and returned to the pool through your existing
piping.
Every situation is different
and the final responsibility for conforming with local regulations,
design and installation of a system lies with the designer/installer/owner.
Dovetail srongly recommends that a qualified engineer design, and be
responsible for Solar Pool Heating Systems
Check
out our pricing for solar heating systems
Back to top